Support / FAQs / About techtown

Home Forums Food Prep Buttons not working – Faema E61 Jubilé A2

Tagged: 

  • Buttons not working – Faema E61 Jubilé A2

     coffeegeek updated 2 weeks, 5 days ago 2 Members · 13 Posts
  • coffeegeek

    Member
    September 6, 2021 at 11:48 am

    I don't know about the 200mA (haven't measured). But around those currents, the 7805 started to breakdown (going under 4V). And it was that voltage I saw in-circuit directly on pin2+3 on 7805. So I'm just assuming 200mA-ish.

    I ohmed all buttons on front panel. OL and ~0R (open/close). I removed CH8 and CH9 from PCB. This helped. Stayed for hours on steady 5V. I then wanted to connect CH8 and CH9, once at a time, to enable just one group at a time. However, CH8 and CH9 is a mix between button panel and water flow sensor. I therefore ohmed the water flow sensors, and wouldn't you know it. One was shot. Measured 77R between + and -. I disconnected the broken flow sensor, and we'll see in a few hours.

Viewing 11 - 11 of 11 replies

Log in to reply.

Original Post
0 of 0 posts June 2018
Now