• General

  Hobart AM14 no start

  Posted by moe777 on September 18, 2025 at 4:36 pm

  I got an am12 pump rebuilt for an AM14 dishwasher. i installed the new pump went to start the dish washer. it fill the tank, stops filling, heats to 160f then sits at idle. i can set the switch to manual mode and it will wash or rinse, if i jump out the rinse or wash jumper it all works fine. but the automatic timed will not start. the control board shows the level, and door switch is working, but there’s a hot motor led on (im thinking one of the motors thermister is not working (one ohms at 60hm the other at 45ohm with a 160F tank) is there something else im missing here? the dishwasher was working fine when the motor tripped the breaker. thanks for the help.

  Martin

  moe777 replied 2 months, 3 weeks ago 1 Member · 0 Replies

  • Hobart
• 0 Replies

Log In to Reply