Posted by apples123 on January 5, 2020 at 11:47 pm
having issues with my Irinox HC 51.20 Blast Chiller. I keep getting the AS1 error even after changing out the temp probe. Any ideas on what else could be causing the issue??
Nice machine to have. The problem you are asking about is going to be one of three possibilities. Either the probe is wrong or not connected to the board. Check the plug on the board if you are certain that the sensor is the correct one. There are a lot of different designs of temperature sensors that look alike but have different values. If all the connections are clean and sound, and the sensor has the correct ohm value, then it will be the board.
Please note:
This action will also remove this member from your connections and send a report to the site admin.
Please allow a few minutes for this process to complete.