Support / FAQs / About techtown

Home Forums Welcome to techtown manitowoc problem IDT1500A

  • manitowoc problem IDT1500A

     fixbear updated 2 days ago 5 Members · 16 Posts
  • fixbear

    Member
    October 21, 2021 at 8:06 pm

    Are you certain that the hot gas solenoid is not opening? Is it getting power to open during harvest? If it is getting power, ohm the coil for continuity. What is the ambient temp the ice machine is in? Is it fully charged? Is the fan cycling working correctly?

    • ule

      Member
      November 5, 2021 at 11:04 am

      Hello, I have reviewed the points that you tell me, but right now it is very bad, it makes a cycle and it is harvested but it does not release the ice and the water cycle begins to melt a little, the ice falls into pieces and sometimes the plate falls , others get stuck and others do the cycle again and the plate becomes very thick, lately it thaws and lasts a long time. Why it puts on thaws for a long time?

  • fixbear

    Member
    November 5, 2021 at 7:54 pm

    go to page 155 in this manual and tell me which paragraph pertains to your unit.

    Manitowoc tech manual

  • Faruk Yaman

    Member
    November 28, 2021 at 1:16 am

    go to page 155 in this manual and tell me which paragraph pertains to your unit...

    This discussion has been very helpful to me, thank you.

    • fixbear

      Member
      November 28, 2021 at 9:41 am

      Glad to hear that.

Viewing 11 - 13 of 13 replies

Log in to reply.

Original Post
0 of 0 posts June 2018
Now