Support / FAQs / About techtown

Sleeve Bushing Bizerba

  • Sleeve Bushing Bizerba

    Posted by ParkerA on July 15, 2021 at 5:38 pm

    Bizerba Sleeve Bushing replacement. I looking to replace the sleeve bushing on our Guide shaft. Any tips on the best method to remove the old one?

    fixbear replied 5 years, 4 months ago 3 Members · 2 Replies
  • 2 Replies
  • olivero

    Organizer
    July 15, 2021 at 8:30 pm

    Do you have a picture?

    IF it's a mteal sleeve, generally, knock'er loose and some torching will help, plastic can sometimes be easier to just break off if it's being replaced.

  • fixbear

    Member
    July 16, 2021 at 9:03 am

    Is this bushing a split steel back bronze? Bizberba uses a lot of them. If so, And you can't make a driver to remove it, I've used a tap and soft drift (to prevent shattering the tap) to drive them out. Other than that it's a Cape chisel and ball peen hammer. Determine the split position, Chisel under the edge to lift the backer inside the bore to overlap and shrink the bushing away from the bore. Easily pulled out with a pair of needle nose pliers from there.

Log in to reply.