Jackson Systems Z-2000-T Thermostat Installation

Installing a Jackson Systems Z-2000-T thermostat is quick and easy. It’s important to make sure each unit is secured in place before turning it on. Follow these instructions to get it installed correctly and move onto setting it up in no time.

How to Remove the Thermostat from the Subbase

• Insert a small coin in the release slot at the bottom of the base.
• Gently twice the coin to release the thermostat from the subbase.
  • Note: Once released, the thermostat will rotate upward as it’s hinged to the subbase.

How to Mount the Thermostat Subbase to the Wall

• Choose a location that represents the ambient room temperature.
• Pull the control wires through the large opening in the thermostat subbase.
• Level and mount the subbase to the wall using the supplied anchors and screws.
  • Note: Do NOT overtighten the mounting screws.
• Check to see that all wires are landed correctly and dressed properly to avoid shorts.

Reattaching the Thermostat to the Subbase

• Place the hinged access cover on by fitting the plastic molded pins into the grooves.
• Carefully align the two standoffs located at the top of the thermostat slots in the top of the subbase.
• Allow the thermostat to swing downward and gently push until the connector pins are fully seated into the terminal blocks.