Support / FAQs / About techtown

Home Forums General Scottman prodigy 330 no ice

  • Scottman prodigy 330 no ice

    Posted by Anonymous on March 4, 2023 at 8:03 pm

    will not make ice,reset and cleaned every thing, unit starts up and runs, compressor and fans are on, good water flow ,goes through cycle to harvest i get flashing code 2 then solid 2 when i open the curtain it looks like there is just a little bit of ice forming. some times i get code 8

    fixbear replied 1 year ago 3 Members · 2 Replies
  • 2 Replies
  • Tito

    Administrator
    March 6, 2023 at 3:50 pm

    You are getting a short cycle code 8 and a Auger motor high load error 2. I would look at the water flow as both of those codes can be related to low water flow or no water.

  • fixbear

    Member
    March 6, 2023 at 10:41 pm

    The flashing code 2 is max harvest. That usually is because the machine needs to be cleaned. With Scotsman Ice Machine Cleaner. Make sure to follow the manual and be especially critical with the sensor. It has to be very clean and dried. They like to short. I always wiped them down with alcohol after cleaning. Also make sure to look at the evaporator closely. Sometimes the plate grids get lifted up from water getting under them and when it freezes it expands. Also check for a harvest assist in the middle of the evaporator. Spring loaded pin on a motor.

Log in to reply.