Support / FAQs / About techtown

Home › Forums › Lincoln 1116 conveyor oven problem

  • Lincoln 1116 conveyor oven problem

    Lincoln 1116 conveyor oven problem

    Posted by guest on January 5, 2017 at 12:00 am

    Hoping someone can help since its too late today to get in touch with tech support. Working on a Lincoln Conveyor Oven model 1116, pre 2011, has a stepper motor control for the conveyor. Getting voltage out of the board (37vdc) with the motor disconnected but it drops to zero when the motor is hooked up. Old motor checked ok, tried a new motor with the same result. Input voltage to the board is ok (29vac red, 10vac brown). Could it be anything other than the stepper control? Thanks-James

    guest replied 7 years, 4 months ago 1 Member · 0 Replies
  • 0 Replies

Sorry, there were no replies found.

Log in to reply.

Log In Register

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .