-
Bunn 2 slush machine bad tic clock
My slush machine is not Frozen and the a message bad tic clock do you what is the problème and do you have thé parts to fix it. Thanks
-
4 Replies
-
What is the model number of this machine?
-
I’ve never seen a time error message on one. I assume that it is probably a Ultra 2A. Correct me if I’m wrong please. The big question is if it’s new and not programmed yet or the same if the control board has been replaced. Normally they only show the torque sensor or the temp sensor as a error. The date, time, serial number and asset number have to be programmed at install. If it was never entered, that may be why time comes up.
-
Thé machine is a ultra -2 ( holder macnine ).Its was stop for a long Time. Then when a plug it the message bad tic clock show and no thing on the board is working the on and off also i have to unplug it to stop it… some people Saïd its the board its not working propely. Thanks
-
Like to verify that you have a Ultra II, not a Ultra II A. They are different.
The most likely problem on that situation is improper assembly or the torque sensing pins are damaged or missing. The auger torque is what determines it the cooling comes on. If it has too much resistance to turning, or any binding, the cooling thinks that it has frozen enough.
Now the membrane pad is a different problem. When they set a long time, residual cleaners and sanitizers seep under the top membrane and corrode the contacts. Especially if stored in non heated spaces where humidity varies. Also when they sit, the connectors on the board oxidize. Often just unplugging and re plugging them will make a difference.
I don’t know where you are, but if you are in a coastal area, they had problems with the drive motor mounts corroding. They came out with a salt air mount to solve it.
Log in to reply.