Support / FAQs / About techtown

Home › Forums › Archives › H

  • Archives

    H

    Posted by guest on May 10, 2018 at 12:00 am

    I have a Pitco Frailator # 40D SM and the unit is about one year old. I Replaced the Thermopile. The Pilot Burns Strong in manual, but the second I release the manual pilot start button, the flame goes out quickly. I have held the button in as long as 5 minutes. Something is not  getting the signal from the thermopile.

    rock replied 5 years, 11 months ago 1 Member · 3 Replies
  • 3 Replies

  • fixbear

    Member
    May 10, 2018 at 3:45 pm

    Check your high limit.

  • eritech1

    Member
    May 10, 2018 at 4:27 pm

    I’ve had a few times where there could be a loose wire covered in grease.

  • rock

    Member
    May 17, 2018 at 8:39 am

    Why did you replace the thermopile?

Log in to reply.

Log In Register

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .