-
hobart 200 mixer sleeve
Hello,
I’ve working on this very old mixer for a week. Can some tell me how to remove the planetary shaft? The sleeve at the bottom is seized in place. The lower clutch gear move up with the shaft about 3/16” too 5/16” . I BELIVE THE SLEEVE WILL NOT MOVE UP TO TIGHTEN THE SHAFT IN PLACE WKEN THE AGITATOR IS INSTALLED. SO i’m stuck !!! Any help would be appreciated
thanks
Ken
-
2 Replies
-
The planetary shaft is held in by a snap ring inside the planetary gear box. You have to drain the box and unbolt the planetary ring and drop as a unit. Same to pull the main shaft, that one has a acorn nut, lock nut, and a fiber washer above the gear that turns the planetary.
-
The planetary shaft is held in by a snap ring inside the planetary gear box. You have to drain the box and unbolt the planetary ring and drop as a unit. Same to pull the main shaft, That one has a acorn nut, lock nut, and a fiber washer above the gear that turns the planetary.
By the way, what’s the ML number?
Log in to reply.