-
Hobart pw20 dishwasher not filling correctly
I’m having a problem troubleshooting a pw20 Hobart dishwasher. The issue is when you turn it on and when it goes into “Fill mode” it doesn’t fill correctly. The top portion of the washer fills but the bottom doesn’t and it just stays on “fill mode”. The only troubleshooting guides I can find for not filling correctly just says to check the incoming water for obstructions but I know incoming water is good due to the top filling and after you hit the power button to shut it off it goes from the “fill mode” to a regular drain cycle and shoots water up from the bottom for rinsing so once again I know there are no obstructions. Any help or advice would be appreciated, also there are a lot of parts that make this thing run and I’m unfamiliar with the equipment so if you suggest checking a sensor or chainring something I would really be thankful if you could be specific as to where it might be located to help me find it. Thank you guys in advance.
Log in to reply.