-
Oven fires but doesnt heat
<dt>TVGS12sc Southbend.
new icm, new sensor, flame starts and get 1.5 flame current, 10 seconds and shut off like it did not sense the flame.
my best guess is to run ground from the burner assembly where the sensor mounts and pigtail it to the ground of chassis and ICM
any other suggestions?</dt><dt>
</dt> -
1 Reply
-
You have flame current, but where and how are you measuring it. Normally the ground connection of the controller. I assume you are talking micro-amps when you state 1.5. If it’s lighting, and has flame current on the ground, then controller it is. Providing you’re not losing power to the controller. Or the power to the controller is out of spec.
Log in to reply.