-
repair
how to remove left panel of a Fri-jado rotisserie model TG4M to replace the steel bearing
-
1 Reply
-
The process for removing the left panel from a Fri-jado TG4M rotisserie model will vary slightly depending on the age of your model, however, the general steps are as follows:
1. Disconnect the power supply and unplug the unit.
2. Remove the top panel by loosening the screws on the back of the unit, and then lifting the panel off.
3. Remove the side panel screws, and then carefully lift the side panel off to expose the bearing.
4. Unscrew the bearing from the shaft, and then remove it from the rotisserie.
5. Replace the bearing with a new one, and then reassemble the unit following the reverse of the steps above.
Log in to reply.