Support / FAQs / About techtown

Forum Replies Created

  • HakimJacob

    Member
    January 7, 2021 at 9:53 am in reply to: scotsman ice maker code 8

    Hi….the Prodigy blunder code demonstrates that the Prodigy has experienced short freeze cycle, a couple of times. On the off chance that the ice machine's collect cycle is set off before 6 minutes into the freeze cycle this blunder code will happen. Understanding the grouping of activity and part capacities will assist you with seeing how to analyze this issue and how to tackle it. One of the primary parts to take a gander at is

    the ice thickness control. You can discover it holding tight top of the evaporator plate, behind the ice shade. This is the place where the ice is made. The ice thickness control is appeared in the image above. This sensor is genuinely near the evaporator plate and as the ice expands the water streaming over it starts to draw nearer to the sensor. Whenever water has connected with the sensor for a couple of moments it will flag the regulator that it's prepared to collect the ice off of the plate.

    https://www.7pcb.com/

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .