Sanchezhvac
Forum Replies Created
-
Both curtain switches are working properly. For the harvest assist, I wasn't sure how they worked, but after talking to someone they told be the harvest assist should start to move when your Hot Gas light is on. I was thinking the harvest assist was not pushing the ice out because it seemed like it was moving forward than stop. As far the ice ot is falling off as a full sheet. What do you mean by half dice?
-
I am aware of the spillway issue they have. I don't think its a spillway issue. As it has a 10-12 minute cycle. Its getting thick enough ice and no water is hitting the ice thickness sensor. The problem is that ice starts sliding out about 2.5 minutes into the harvest. By time the second ice drops it has maxed out on harvest.
-
I have C1848SW-32A. It has a left and a right evaporator. I have done everything and still getting the Code 2 Flashing. I believe all the Nickel plate is gone on the evaporator grid.
-
Another thing what the normal freeze cycle time?
-
Now I'm scratching my head because this machine was just cleaned. Not sure how much more we can clean it. I can probably run some cleaner though it again and see if it makes any difference. How have you seen the harvest assist probes fail?
-
When I got to the ice machine there was a Code 2 Max Harvest Time. It looked like the harvest assist probe wasn't pushing out all the way so I manually pushed it in and out a few times. It made ice twice after that without no Code 2. Then the third time it wabout 6-10 minutes into the freeze cycle it started to flash Code 8. So now im trying to see what these two codes have in common.
-
Another thing does anybody have like a parts breakdown of this machine?
-
The ice machine is only about 2 years old so nothing has been replaced in it. This is the first issue this customer has had since its been installed. I don't know why a filter was never installed.
-
Thank you, yea the water level keeps rising when the watet fill light is off. This ice machine doesn't have a water filter installed so im thinking scale build up or something. I will check it tomorrow.
-
What was causing the alarm? I'm having the same problem.