Support / FAQs / About techtown

Home Forums General Blodgett DFG 100-3

Tagged: 

  • Blodgett DFG 100-3

    Posted by chin on May 22, 2024 at 12:29 pm

    I’m looking for an updated wiring diagram for a new style blower motor. the new motor has less leads and the run capacitors are in the junction box of the motor instead of the control panel of the oven.

    fixbear replied 3 weeks, 2 days ago 2 Members · 3 Replies
  • 3 Replies
  • fixbear

    Member
    May 23, 2024 at 10:53 am

    The Motor wiring is on the cover of the new motor. If the old one had separate mounted capacitors, You can just remove them. Check the wiring diagram attached to the oven. Tito may be able to get one from Blodgett for your conversion. But there should have been paperwork with the motor for it. I don’t know enough of your oven as they used multiple control systems and single, two, and three speed motors.

  • chin

    Member
    May 23, 2024 at 11:55 am

    Its a 2 speed motor. I was looking for the conversion diagram and what jumpers are needed for the conversion. the motor did not have anything with it, just the motor.

    • fixbear

      Member
      May 24, 2024 at 10:20 pm

      Two speed will need a common, high, and low wire. Also proofing switch that it is running before heat can come on.

Log in to reply.