Support / FAQs / About techtown

Home Forums Welcome to techtown Help with WINSTON Holding Cabinet 4000A-Series

Tagged: 

  • Help with WINSTON Holding Cabinet 4000A-Series

     MONEY updated 6 days, 4 hours ago 2 Members · 4 Posts
  • MONEY

    Member
    December 3, 2019 at 12:39 pm

    Hi,

    Looking for a Drain Tube and End cap for this unit. 

    See Picture attached. 

    Don’t have model or Serial so not sure if anyone can help. 

    Thank you!


    Attachments:
  • fixbear

    Member
    December 3, 2019 at 1:41 pm

    You should be able to find the makers plate at the bottom right just above the leg front.  But with the picture you sent, I know it has to be a H model Depending on the volume and number of doors It will probably be a HA4xxx.  You can always measure the height, width, and dept to determine the model.  Here is a parts book that will cover it;  
    https://www.partstown.com/modelManual/WIN-HA4-SERIES_spm.pdf

    Now you never said it it was a self fill or manual humidifier model.  I think your drain cap may be this;  https://www.partstown.com/winston/winps1654  and your pipe this;  https://www.partstown.com/winston/winps1629  This is for the HA4023.   Not sure if it is correct for what ever model you have.  I’d call once I found the model.

    Good luck.

  • fixbear

    Member
    December 3, 2019 at 1:49 pm

    You should be able to find the makers plate at the bottom right just above the leg front.  But with the picture you sent, I know it has to be a H model Depending on the volume and number of doors It will probably be a HA4xxx.  You can always measure the height, width, and dept to determine the model.  Here is a parts book that will cover it;   manual

    Now you never said it it was a self fill or manual humidifier model.  I think your drain cap may be this;  https://www.partstown.com/winston/winps1654  and your pipe this;  https://www.partstown.com/winston/winps1629  This is for the HA4023.   Not sure if it is correct for what ever model you have.  I’d call once I found the model.

    Good luck.

  • MONEY

    Member
    December 3, 2019 at 3:50 pm

    Thank you Very Much!

Log in to reply.

Original Post
0 of 0 posts June 2018
Now