russfesco
Forum Replies Created
-
If the oven continues to run and it just stops heating, If there are no limits tripped then you need to check the air switch. The switch must be made in order for the unit to heat. If the air tube becomes blocked for some reason it can cause this to happen. Could also be a faulty air switch.
-
First, check and make sure the sensing bulbs are still connected to cap tubes, Then make sure the bulbs are still mounted correctly in bracket. If all check correct then double check the calibration after the unit has reached set temp and cycled on/off at least 4 times. Also check temp in the correct location in the oil. Middle front to back. middle left to right, and 1 inch into the oil. If you have to turn the calibration screw in the thermostat, be sure to put some nail polish on the screw when done to lock it in place.
-
Thank you for the reply. This location actually has a second unit right next to the troubled unit and it has never had any issues. pressures hold great and frost is even from 1 end to the other. The bulb is mounted in the exact same place on both units, and both valves are identicle. Been waiting over a week now for the factory engineers to decide what they want to do next. Just lookin for ideas to try and not to look so bad to customer.
-
Also get the thermocouple p/n m1265x
, sorry.
-
Parts Town is actually showing the replacement part for this. The p/n is R3104x. It's a combination gas valve.